top of page
Full metal Hotend + BMG Extruder upgrade

Full metal Hotend + BMG Extruder upgrade

$99.00Price
GST Included
 
Wow are we impressed with the performance of this TriangleLab full metal Hot-end and Extruder upgrade kit. This awesome upgrade setup greatly improves printing performance and speed. 
 
Please refer to documentation below in the "Technical Support / Documentation" section for more info.
 
 
Supported 3D printers
CR-10S
CR-10S -S5
CR-10S -S4
CR-10
CR-10 -MINI
CR-20
CR-20 PRO
Ender2
Ender3
Ender3 PRO
TronXY X5S
Tevo Tornado
 
Parts Included
1 x Mini BMG Extruder
1 x BLUE PTFE TUBE 1M
1 x HeatSink 
1 x Titanium alloy heat break
1 x CR-10 Heater Block                                       
1 x Silicone sock
1 x 0.4MM Nozzle (Brass)
1 x Thermistor (NTC 100K B3950)
1 x Heater Cartridge(12v or 24v)

  • Technical Support / Documentation

    Basic Tips

    Recommended slicer setting:

    retraction speed  over 80MM/S

    retraction length 2.5-4MM

     

    If you are facing a PLA clogging problem，please try the followings:

    1. Increase the retraction speed. The speed may have being  limited in the firmware try to change it. G-command "M203 E200"

    2. Increase the extruder  acceleration.  check your firmware settings. G-command "M201 E9000"

    3. Reduce the retraction length. It may vary on your machine setup.

    4. Increase the nozzle temperature by 5-10 degrees.

    5. Do not install the 2 screws for support the heatblcok like the stock hotend on a CR-10 printer.

    6. Make sure that there is no gap between the heatsink and the heat breaker.

    Modifying Marlin firmware to work with the upgrade

    Please see this documentation HERE

     

bottom of page