All of our TurboCut endmills are sent via Australia post express for speedy replacement
These 2 flute round bottom cutters are great for signage applications where a radiused bottom is required. They are easy to use and can used at full depth.
Recommended for
- Wood & timber (MDF, ply, hardwoods)
- Plastics (ABS, HPDE, Delrin and other softer plastics)
Head width: 10mm
Shank size: 6mm
Please Note
Be careful when cutting or engraving MDF and some particle timber products as they produce alot of fine dust that can irritate the throat, eyes and lungs. It is recommended to use a dust shoe and suitable dust extraction system when machining these products.
It is recommended to have a slow Z plunge rate and do a full depth of cut per pass. A word of warning; Do not exceed the maximum depth of the cutting head itself.
TurboCut 10mm Round bottom bit
BULK BUY: 10% off for 10 or more*
Endmill Size Total Overall Length 10x6mm 40mm ** These are approximate overall lengths. This information should only be used as a guide. We recommend measuring the bit after you receive it for exact measurements **
The 10% bulk discount applies only when you purchase 10 or more of the same type of endmill, in the same transaction.
You can mix sizes within that type, but all 10 must be the same endmill type.
Orders combining different endmill types to make up 10 units do not qualify for the discount.