All of our TurboCut endmills are sent via Australia post express for speedy replacement
These zero flute diamond cutter is specifically designed for clean 90° foam cutting and for working on stone, marble, granite and ceasar stone. Unlike most cutters these bits grind material away rather than cut.
These endmills have a cutter width of 20mm with a depth of 12mm and a shank of 8mm!
Recommended for
- Foams
- Stone
- Marble
- Granite
- Ceasar stone
Please Note
It is recomended to run these endmills with coolant flood if engraving any type of stone. Failure to do so will result in a large amount of airborne particulate which is very hazardous to your health and may cause the cutter to burn out.
Please note: These will NOT fit a 1.5kW spindle or an ER11 collet, such as those supplied standard with CNC3D QueenBee, Ultimate Bee and QB2 machines. ER11 collets have a maximum shank capacity of 7mm.
Suggested feeds and speed for stone
Spindle RPM: 20,000rpm
Z plunge rate: 100-300 Engraving depth-0.5mm-5mm
X&Y Feed rate: 1000-3000mm/m
TC 20mm 90° Diamond cutter (Foams, Stone, Marble)
BULK BUY: 10% off for 10 or more*