All of our TurboCut endmills are sent via Australia post express for speedy replacement
These chamfering endmills have been specifically designed for adding clean chamfers on sharp machined edge. This design allows for excellent chip ejection and reduces chip welding.
There is both 2 Flute (2F) and 3 Flute (3F) options available in this listing.
These endmills are made from solid carbide and have a HRC55 hardness coating.
Recommended for
- Aluminium
- Plastics
- Mild steel
Please Note
Please be aware that the 8mm variants of these endmills will not fit in an ER11 collet such as those that are standard with a CNC3D QueenBee or QB2 machine. The maximum size cutting bit that will fit in your ER11 collet is 7mm.
TurboCut 2 Flute / 3 Flute Chamfering endmill (HRC55)
BULK BUY: 10% off for 10 or more*
Endmill Size Total Overall Length 90°x2x4mm 50mm 90°x3x3mm 50mm 90°x4x4mm 50mm 90°x6x6mm 50mm 90°x8x8mm 60mm ** These are approximate overall lengths. This information should only be used as a guide. We recommend measuring the bit after you receive it for exact measurements **
The 10% bulk discount applies only when you purchase 10 or more of the same type of endmill, in the same transaction.
You can mix sizes within that type, but all 10 must be the same endmill type.
Orders combining different endmill types to make up 10 units do not qualify for the discount.