top of page
COB Cutter (PCB, Fibreglass, Carbon fiber)

COB Cutter (PCB, Fibreglass, Carbon fiber)

PriceFrom $9.00
GST Included

BULK BUY: 10% off for 10 or more*

 
All of our TurboCut endmills are sent via Australia post express for speedy replacement
 
These COB cutter endmills are designed for milling and engraving resin composite products such as PCB, fibreglass and carbon fiber panels. They tend to have more of a grinding effect rather than a cutting effect.
 
 
Recommended for
 
  • Printed circuit board (PCB)
  • Fibreglass panels
  • Carbon fiber panels
 
Please Note
Be careful when cutting or engraving any resin composite materials as they produce alot of fine dust that can irritate the throat, eyes and lungs. It is recommended to use a dustshoe and suitable dust extraction system when machining these products.
Quantity

  • Specifications

    Endmill Size Total Overall Length
    0.5x3x3.175mm 36mm
    0.6x4x3.175mm 35mm
    1x7x3.175mm 35mm
    1.5x8x3.175mm 35mm
    2x10x3.175mm 38mm
    2.5x12.x30175mm 30mm
    3x12x3.175mm 38mm
    4x25x4mm 45mm
    6x32x6mm 60mm

     

    ** These are approximate overall lengths. This information should only be used as a guide. We recommend measuring the bit after you receive it for exact measurements **

  • Bulk Buy Discount Disclaimer:

    The 10% bulk discount applies only when you purchase 10 or more of the same type of endmill, in the same transaction.

    You can mix sizes within that type, but all 10 must be the same endmill type.

    Orders combining different endmill types to make up 10 units do not qualify for the discount.

No Reviews YetShare your thoughts. Be the first to leave a review.
bottom of page