Hi. Can you please help me with wiring Axbb-e with chinese laser that have 3 pin input (12v,gnd,pwm). Can you please provide me shematic how to wire, because i dont really get it.
@frank rugolo Hi. Can you please help me with wiring Axbb-e with chinese laser that have 3 pin input (12v,gnd,pwm). Can you please provide me shematic how to wire, because i dont really get it.
the pictures i have uploaded show the exact way it should be connected
why can I not download the pdf file, I tried it about 10 times and it just keeps on timing out ?
cheers
nick
Hi. Can you please help me with wiring Axbb-e with chinese laser that have 3 pin input (12v,gnd,pwm). Can you please provide me shematic how to wire, because i dont really get it.
Thx in advance
Thanks so much for all the info. Appreciate the effort you have done. I'm sure it will help other as well. Thank mate.
Once all hooked up and it is starting the spindle as it should
but then throws an estop and shut the spindle down this is a grounding
issue from your end stops or even the spindle if not grounded properly.
the AXBB-E is a very good unit but it is also very sensitive .
i had this issue to begin with but i knew it was not my water cooled spindle
because i grounded it when installing. what you need to do is disable any end stop activated in uccnc and test to see if it runs as it should.
If it does then you need to activate one at a time to see which is throwing the error.
In the end i needed to install ferrite cores to all my end stop cables and steppers
this resolved the issue for me . Also all my cables are shielded
havent played with for a bit but will take a few pics and send them through . been busy playing with the 100w co2
Pictures are worth a thousand words lol. Any chance of some pictures of your set up as I'm still in the build phase.
Cheer's.
cheers mate here are the details for connecting the Chinese diode laser
setups . mine is a 15w unit
Well done Frank, very useful information. nice work getting it all going!