Generic 2.2kw VFD (240v or 3 phase input) Kit

 
These awesome digital VFDs can be used for constant torque loads ( such as hard starting: Air compressors, HVAC units) and variable torque loads (such as pumps, fans, etc). It can be used as a motor speed control and a phase converter. The input for this VFD supports either a 240V single phase or 3 phase input. 
 
They support full range speed adjustment from ~100rpm to 24,000rpm and are designed to control 3 phase motors on Lathes, Mills, Car Hoists, Pumps & Conveyors, grinders, the options are endless.
 
These VFDs support either an external potentiometer for speed control or PWM speed control from a microcontroller. You can also adjust the speed using the + or - buttons on the front of the LCD panel.
 
The efficient design of these VFDs with built-in heatsink and cooling fan allows the unit to run continuously for hours of use at full load.
 
Frequency Control
Range: 0.1~400.0Hz
Accuracy: Digital: 0.1%（-10~40℃）; Analog: 0.1% （25±10℃）
Setting Resolution: Digital: 0.1Hz; Analog: 1‰ of max. Operating frequency
Output Resolution: 0.1Hz
Operator Setting Method: Press directly ←∧∨ to set.
Analog Setting Method: External Voltage 0-5V，0-10V，4-20mA，0-20mA.
Other Functions: Frequency lower limit, starting frequency, stopping frequency, three skip frequencies can be respectively set.
 
General Control
Ramp Control: Selectable 4-speed steps ramp-up and -down time (0.1-6500s). 
Torque Control: Torque increase settable, the starting torque can reach 150% at 1.0Hz. 
Multi-Inputs: 6 multi-function input terminals for 8–speed step control, program operation, switching of 4-speed Ramp, UP/DOWN function, counter, external emergency stop and other functions. 
Multi-Outputs:5 multi-output for displaying of running, zero speed, counter, external abnormity, program operation and other information and warnings. 
Other Functions: Auto Voltage Regulation (AVR), Decelerating Stop or Coasting Stop, DC Braking, Auto Reset and Restart, Frequency Track, PLC Program Control, Traverse Control, Drawing Control、Auto Energy Saving, Carrier Adjustable (Up to 20KHz), etc. 
 
Protection Functions
Overload Protection: Electronic relay protection 
Fuse Protection: Internal fuse provided 
Over-voltage: DC Voltage ＞400V. 
Under-voltage: DC Voltage ＜200V. 
Restart After Instant Stop: Restart with Frequency Track 
Stall Protection: Stall protection in ramp operation 
Output Short Circuit: Electrical circuit protection 
Other safety features: electronic over-heat protection, restriction of reverse running, direct start after power on, fault reset, parameter lock PID, one-drive-more, etc. 
 
No wiring is supplied with with Unit. If you wish to purchase some spindle cable suitable for this VFD then check out our high quality VFD cable here
 
**Please note: 
Due to the volatile nature of VFDs, CNC3D provide minimal support for configuring and setting up any VFD. Under Australian Law all 240V work MUST be completed by a licenced Electrician.
 
If you do not have experience setting up VFD's, we do not recommend changing any settings yourself and to seek advice from your licensed electrician that is installing your VFD for you. 
 
Failing to configure your VFD correctly may result in catastrophic events occurring such as the VFD physically exploding if settings are not configured correctly prior to powering on any VFD - this may void your warranty
 
As these are generic VFDs, they may vary in appearance and colour.