top of page
1 Flute Upcut endmill for Plastic & Acrylic

TurboCut 1 Flute Upcut (Plastic & Acrylic)

PriceFrom $6.00
GST Included

 

All of our TurboCut endmills are sent via Australia post express for speedy replacement

 

These 1 flute Upcut endmills have been specifically designed for cutting plastics and acrylic. They are designed to cut smoothly and eject as much swarf as possible without causing the material to melt and jam up the endmill.

 

Recommended for

  • Plastics (ABS, acrylic, HPDE etc.)

 

Please Note

It is recomended to run these endmills at the fastest feedrate safely possible and the lowest RPM to reduce the chance of clogging the flutes with melted plastic or acrylic.

 

It is not recommended to use these endmills for wood as it's upcutting profile will leave a rough surface edge on your timber.

  • Specifications

    Endmill Size Total Overall Length
    1x4x3.175mm 38mm
    1.5x5x3.175mm 38mm
    2x6x3.175mm 38mm
    2x8x3.175mm 38mm
    3.175x8x3.175mm 38mm
    3.175x17x3.175mm 38mm
    4x15x4mm 50mm
    4x22x4mm 50mm
    6x12x6mm 50mm
    6x22x6mm 50mm

     

    ** These are approximate overall lengths. This information should only be used as a guide. We recommend measuring the bit after you receive it for exact measurements **

bottom of page