All of our TurboCut endmills are sent via Australia post express for speedy replacement
These surfacing bits are designed for face cutting your spoilboard to ensure that the bed is perfectly perpendicular to your spindle or router. Simply fit one of these cutters to your router/spindle and run at 20% lower speed than your usual endmills for the same material type. Perform 1mm cuts on your surface at a time until the whole surface has been cut.
Recommended for
- Wood & timber (MDF, ply, hardwoods)
- Plastics (HDPE, PVC, ABS)
Please Note
Due to the size of these bits, ensure they are mounted as high as possible into the router/spindle to reduce any run-out and possible breakages.
Be careful when cutting or engraving MDF and some particle timber products as they produce alot of fine dust that can irritate the throat, eyes and lungs. It is recommended to use a dustshoe and suitable dust extraction system when machining these products.
CNC Surfacing Bit
BULK BUY: 10% off for 10 or more*
Endmill Size Total Overall Length 22x17x6mm 50mm 22.2x17x6.35mm (1/4") 50mm ** These are approximate overall lengths. This information should only be used as a guide. We recommend measuring the bit after you receive it for exact measurements **
The 10% bulk discount applies only when you purchase 10 or more of the same type of endmill, in the same transaction.
You can mix sizes within that type, but all 10 must be the same endmill type.
Orders combining different endmill types to make up 10 units do not qualify for the discount.