All of our TurboCut endmills are sent via Australia post express for speedy replacement
These tapered ballnose endmills are designed specifically for doing detailed 3D carvings in a variety of materials up to a hardness of HRC55. They perform extremely well with very complex designs and can leave an outstanding finish on most materials.
Recommended for
- Plastics (ABS, acrylic, HPDE etc.)
- Wood - Soft / Hard / Ply / Composite
- Aluminium & Brass
TurboCut Tapered Ballnose for 3D Carving (HRC55)
BULK BUY: 10% off for 10 or more*
Endmill Size
(Radius x Cut Length x Shank Diam )
Total Overall Length R0.25x15x4mm 50mm R0.5x15x4mm 50mm R0.75x15x4mm 50mm R1x15x4mm 50mm R0.25x20.5x4mm 50mm R0.75x20.5x4mm 50mm R1.5x30.5x6mm 75mm R2x30.5x6mm 75mm ** These are approximate overall lengths. This information should only be used as a guide. We recommend measuring the bit after you receive it for exact measurements **
The 10% bulk discount applies only when you purchase 10 or more of the same type of endmill, in the same transaction.
You can mix sizes within that type, but all 10 must be the same endmill type.
Orders combining different endmill types to make up 10 units do not qualify for the discount.