All of our TurboCut endmills are sent via Australia post express for speedy replacement
A compression cutter starts with a 4mm up cut section then has the rest of the cutting area a downcut, they are specifically designed to leave a clean finish on both top and bottom surfaces when profile cutting. They are also much quieter in operation than a 2F straight cut and produce cleaner side edges.
These endmills are made from solid Japanese carbide and have no coating at all.
Recommended for
- Wood (All types and hardnesses)
Please Note
Compression cutters like to run a bit faster than other wood cutting bit to get the best finish along the side of your material.
Please be aware that the 8mm variants of these endmills will not fit in an ER11 collet such as those that are standard with a CNC3D QueenBee or QB2 machine. The maximum size cutting bit that will fit in your ER11 collet is 7mm.
TurboCut 1 Flute Compression endmill
BULK BUY: 10% off for 10 or more*
Endmill Size Total Overall Length 3.175x17x3.175mm 40mm 4x22x4mm 45mm 6x22x6mm 50mm 6x25x6mm 50mm 8x35x8mm 70mm 8x52x8mm 100mm ** These are approximate overall lengths. This information should only be used as a guide. We recommend measuring the bit after you receive it for exact measurements **
The 10% bulk discount applies only when you purchase 10 or more of the same type of endmill, in the same transaction.
You can mix sizes within that type, but all 10 must be the same endmill type.
Orders combining different endmill types to make up 10 units do not qualify for the discount.