All of our TurboCut endmills are sent via Australia post express for speedy replacement
Specifically designed for 3D carving, engraving and lettering these 2 flute ball nose endmills are great a cheaper alternative to tapered ball nose endmills.
These endmills are made from solid Japanese carbide and have no coating at all.
Recommended for
- Wood (All types and hardnesses)
Please Note
It is recommended to run these endmills against the grain for optimal results. Check to see if your CAM software has the option to "Raster engrave".
IMPORTANT NOTE:
We have made a change to our product listing format for this item.
Previously, we used Diameter x Length x Shank. Now, to align with other ballnose endmills, we're using Radius x Length x Shank.
EG. what was previously listed as 2 x 22 x 3.175mm is now shown as R1 x 22 x 3.175mm.
TurboCut 2 Flute Spiral Ballnose (3D carving)
BULK BUY: 10% off for 10 or more*
Endmill Size
(Radius x Cut Length x Shank Diam)
Total Overall Length R0.5x4x3.175mm 38mm R1x22x3.175mm 40mm R1.587x22x3.175mm 40mm R2x52x4mm 80mm R3x42x6mm 70mm ** These are approximate overall lengths. This information should only be used as a guide. We recommend measuring the bit after you receive it for exact measurements **
The 10% bulk discount applies only when you purchase 10 or more of the same type of endmill, in the same transaction.
You can mix sizes within that type, but all 10 must be the same endmill type.
Orders combining different endmill types to make up 10 units do not qualify for the discount.