All of our TurboCut endmills are sent via Australia post express for speedy replacement
Featuring strategically placed grooves along its linear flutes, our TurboCut 3 Flute Straight Chip Breakerendmill effectively manages chip formation, preventing long, stringy debris while leaving a clean top and bottom finish.
Recommended for
- Wood & timber (MDF, ply, hardwoods, softwood, laminate)
Please Note
Be careful when cutting or engraving MDF and some particle timber products as they produce a lot of fine dust that can irritate the throat, eyes and lungs. It is recommended to use a dustshoe and suitable dust extraction system when machining these products.
Please be aware that the 8mm variants of these endmills will not fit in an ER11 collet such as those that are standard with a CNC3D QueenBee or QB2 machine. The maximum size cutting bit that will fit in your ER11 collet is 7mm.
TurboCut 3 Flute Straight Chip Breaker
BULK BUY: 10% off for 10 or more*
Endmil Size Total Overall Length 4x22x4mm
50mm
4x32x4mm
75mm
6x22x6mm
50mm
6x42x6mm
100mm
8x32x8mm
75mm
8x42x8mm
100mm
** These are approximate overall lengths. This information should only be used as a guide. We recommend measuring the bit after you receive it for exact measurements **
The 10% bulk discount applies only when you purchase 10 or more of the same type of endmill, in the same transaction.
You can mix sizes within that type, but all 10 must be the same endmill type.
Orders combining different endmill types to make up 10 units do not qualify for the discount.