the pictures i have uploaded show the exact way it should be connected

thanks all sorted the version i was running didnt have the checkbox.

thought i would have a play with the commander software and my small cnc but for the life of me even after re-keying the pendant in the settings it would not work. i then installed the latest version and it does not even have the settings to check etc.

Once all hooked up and it is starting the spindle as it should but then throws an estop and shut the spindle down this is a grounding issue from your end stops or even the spindle if not grounded properly. the AXBB-E is a very good unit but it is also very sensitive . i had this issue to begin with but i knew it was not my water cooled spindle because i grounded it when installing. what you need to do is disable any end stop activated in uccnc and test to see if it runs as it should. If it does then you need to activate one at a time to see which is throwing the error. In the end i needed to install ferrite cores to all my end stop cables and steppers this resolved the issue for me . Also all my cables are shielded

havent played with for a bit but will take a few pics and send them through . been busy playing with the 100w co2

cheers mate here are the details for connecting the Chinese diode laser setups . mine is a 15w unit